How to Install HyperX Pudding Keycaps 2 PBT Full Set

By High Quality Gaming Gear —— HyperX ROW | Published: 2026-10-25

Category: How-to Guides

Step-by-step guide to installing your HyperX Pudding Keycaps 2 PBT full set. Learn how to replace keycaps safely, avoid common mistakes, and get the best RGB glow.

Quick Answer

To install your HyperX Pudding Keycaps 2 PBT full set, remove the old keycaps with a keycap puller, align each new keycap by its stem orientation, and press firmly until it clicks. Take extra care with the space bars and stabilizer keys to avoid bending the wire.

Why Choose PBT Pudding Keycaps

The HyperX Pudding Keycaps 2 are made from double-shot PBT, which resists the greasy shine that develops on ABS keycaps over time. The translucent bottom half lets your keyboard's RGB shine through for a brighter, more uniform glow.

This full set includes extra keycaps for 65% and 75% layouts, plus two custom space bars. The HyperX font is designed for clarity, and the thick PBT construction feels more solid under your fingers.

Before You Start: Tools and Prep

You only need a keycap puller (often included with the keycap set or your keyboard). Work on a clean, flat surface with good lighting. Unplug the keyboard to avoid accidental key presses while swapping caps.

Lay out the keycaps by row so you can quickly find the correct profile. The HyperX Pudding Keycaps 2 set uses a standard OEM profile, so the rows are slightly angled. Check the underside of each cap for a small row identifier if you are unsure.

Installation Steps

Remove the Old Keycaps: Use a wire-style keycap puller. Grip the keycap from both sides, wiggle gently, and pull straight up. Avoid twisting, which can bend the switch stem. Start with the alphanumeric keys, then remove the larger keys like Shift, Enter, and Space. Common mistake: pulling at an angle. Always pull straight up to protect the switch.
Identify Stabilizer Keys: Space bar, Shift, Enter, and Backspace have stabilizer wires underneath. Set these aside separately. The HyperX Pudding Keycaps 2 set includes two custom space bars; choose the one that matches your keyboard's stabilizer layout (standard or offset). Check that the stabilizer wire sits in the correct clip on the keycap before pressing down.
Install the New Keycaps by Row: Align each keycap so the stem hole matches the switch stem orientation. Press down until you hear a click. Work row by row, starting from the top. For the space bar, press evenly on both sides to ensure the stabilizer clips engage fully. Common mistake: forcing a keycap that does not line up. Rotate it 180° if it feels misaligned.
Test Each Key: Plug the keyboard back in and press every key. Listen for a consistent click and check that the keycap does not wobble. For stabilizer keys, press at the edges to confirm the wire is seated. If a key feels mushy, remove the cap and reseat it. A rattly space bar usually means the stabilizer wire is not clipped in. Remove and reinstall carefully.

Product Details

HyperX Pudding Keycaps 2 - Full Key Set - PBT: HyperX Pudding Keycaps 2 feature a translucent dual-layer style and our signature HyperX font, both designed to provide extra brilliance. The dual-layer design lets more RGB light pass through, and the clear font makes each key easier to read in low light.
HyperX Pudding Keycaps 2 - Full Key Set - PBT